Can some one please explain how the
SM3D12 operates when the "store" command from a Pansat 2300 USALS setup screen is used. Although this may sound like a "receiver" question it is also a motor question since I am unable to determine if the motor is defective, or I do not understand the proper use of USALS commands.
To explain. On several occasions now - during setup of USALS - my SM3D12 has rotated to its extreme east limit & stopped there. Usually, the setup & operation of the motor works fine. It is only rarely & unexpectedly that this happens. When it stops at the east limit, it will not respond to any further USALS commands from the receiver. I am however, able to use Diseqc 1.2 commands, or the switches on the bottom of the motor, to manually rotate it away from the east limit.
Since I do not understand how this can happen; I may be causing it by improper use of receiver commands during setup of USALS.
Your helping me to better understand the use of your motor will be very much appreciated.
Best regards