So far I have not been able to read the manual because the wordpad document doesn't load properly. I also tried MS Works and even though the document loaded, it was mostly pages of unintelligible characters.
Perhaps you can put some simple instructions on the
installation support page for the
Twinhan just as you do for the Fortec, etc. Also, right now I am connecting direct without the
DiSEqc switch. Can't figure out how to set it up and it appears to be very lossy.
I might just try using a simple A/B switch to change from C to Ku. It's been fun watching the programs that I have managed to scan so far. I also know that I need to align my dish for better signal.